How the two link to each other
- In the exterior model below, there is a pin on the building marked iGuide Tour. Click it, the interior tour opens right there, on top of the model, without leaving the page.
- In the interior tour further down, there is a tag marked 3D Model. Click it, this same exterior model opens inside the tour.
- Neither one is a link that sends you away. Each lives inside the other. Try both.
Exterior 3D mesh model
hosted on NIRA, opens in a new tab if it does not load below
Drone captured photogrammetric mesh. Orbit, pan and zoom with the tools on the left of the frame. The pin marked iGuide Tour is on the building itself, you may need to orbit or zoom to find it. It opens the interior tour without leaving this view.
Interior iGUIDE virtual tour
iGUIDE, embed URL, sanctioned parameters only
Navigable 360 tour. The tag marked 3D Model is placed near the entry, open the floor plan panel bottom left if you cannot see it from the start position.
Measured, not estimated
Fetching live from the iGUIDE View API…
| Floor | Interior area |
|---|
Fetched live from iGUIDE at the address above, not typed in by hand. iGUIDE reports its measurement standard for this tour as rms, unconfirmed against Planitar's own definition as at 18th August 2026. This is not a PCA Method of Measurement figure, not a lettable area, and not a substitute for a survey. Where a room shows no computed area, it is listed as such rather than left off.
Fetched live from iGUIDE, not typed in. Not a lettable area and not a substitute for a survey. Full measurement basis.